The rear mount is our favorite for taking great videos. Nothing in the way of the camera to get those up close photos.

The rear mount attaches to the stock passenger footpeg holes.

All stainless steel hardware is included for a simple bolt on installation. It uses the same camera mounting bracket as the front mount so you can change from the front to the back in seconds. A velcro safety strap is also included.

INSTALLATION:

A - Main Bracket B - 5/16 Screw C - Adjustor Bracket D - Adjustment Knob E - Camera Platform

F - Extension arm G - Adjustment Spacer H - 8MM bolts I - Footpeg Spacers J - Optional Nuts

• Remove the left passenger peg bracket.
• Place washers on bolts (H), insert through main bracket (A), install spacers (I) and bolt to stock passenger peg mounting holes. If the stock holes are not threaded you can use the nuts (J) to secure the assembly.
• Now it’s time to install the camera mounting hardware.
• Before the next step, be careful when mounting your camera as they are mostly plastic. If you strip the bottom mounting hole, your camera may not be able to be repaired.
• Turn your camera upside down and place camera platform (E) on bottom of camera. Place the adjustor bracket (C) on the camera platform (E) and install the screw through both and tighten assembly to camera. Now you can assemble the adjustor bracket (C) onto the extension arm (F).
• Make sure to use the supplied spacer and lockwasher.

Tightening The Camera
Rotate camera backwards, tighten knob (D). Rotate camera forward while continuing to tighten. This step can be repeated until the camera is tight.

Removing Camera
Rotate camera backwards as you loosen knob.

Don’t forget to use the velcro safety strap to secure the camera to the main bracket. You can remove the small front screw on the angle adjuster (C) to swivel a video camera or mount a still camera.